Screen Innovations SI.FI Quick Start Manual

SI.FI Quick Start Guide
COMPLIANCE STATEMENTS
1. FCC Statement
a. The IMC-300MKII-xx Controllers have been tested and found to
comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
i. Reorient or relocate the receiving antenna.
ii. Increase the separation between the equipment and receiver.
iii. Connect the equipment to an outlet on a circuit different from
that to which the receiver is connected.
iv. Consult the dealer or an experienced radio/TV technician for help.
2. ICES
a. This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est confirme á
la norme NNB-003 du Canada.
SYSTEM REQUIREMENTS
1. Computer/tablet/mobile requirements
a. PC running Windows 7 or higher
b. Chrome 59.0.3071 or higher
**After SI.FI firmware upgrades and motor commissioning is completed with a compatible PC, a mobile device may
be used to control the motors.**
2. Power requirements (use one of the following):
a. PoE provided by a PoE switch plugged in to the ethernet port of the SI.FI.
b. 24v DC to port 1 via the provided passive PoE injector.
**Port 1 of the SI.FI can not take more than 24v DC. Any voltage higher than 24v DC supplied to port 1 may cause irreparable
damage to the unit.**
3. Network requirements
a. Use 22-24 AWG CAT5 (or higher) interconnect wires with a maximum length of 328 ft. (100m).
b. An active internet connection for firmware upgrades
i. Accessing a SI.FI remotely requires port forwarding on the site's network.
Screen Innovations 9715 B Burnet Road, Suite 400 Austin, TX 78758 (512) 832-6939
Reset (Under
Removable Cap)
Port 1 (3rd Party Serial Connections)
PoE
Port 2 (SDN bus)
Version 1.0