Section 8: Adjustments - MTD 410 Series Operator's Manual

6. After engine starts, move throttle control to
desired engine speed. (Mower is designed to be
operated at full throttle.)
NOTE:
If any problems are encountered, refer to
the Trouble Shooting Guide on Page 16.
TO STOP ENGINE AND BLADE
1. Move throttle control lever to the SLOW position.
2. Release the blade control handle to stop the
engine and blade.
WARNING:
rotate for a few seconds after the engine
is shut off.
3. Disconnect the spark plug wire and ground it
against the engine to prevent accidental starting
while equipment is unattended.
USING YOUR ROTARY MOWER
WARNING:
without either the rear deflector or entire
grass catcher assembly in place.
Be sure that lawn is clear of stones, sticks, wire, or
other objects which could damage lawn mower or
engine. Such objects could be accidentally thrown
by the mower in any direction and cause serious
personal injury to the operator and others.
For the best results, do not cut wet grass because it
tends to stick to the underside of the mower, prevent-
ing proper discharge of grass clippings, and could
cause you to slip and fall. New grass, thick grass or
wet grass may require a narrower cut. Blade speed
should be adjusted to the condition of the lawn.

SECTION 8: ADJUSTMENTS

WARNING:
any adjustment to lawn mower without
first stopping
disconnecting spark plug wire.
CUTTING HEIGHT ADJUSTMENT
An adjusting plate and thumb lever at each wheel
position provides cutting height adjustment. Each
adjusting plate has nine height positions. Height of
cut will be changed when the thumb lever is moved
from one hole to another. Simply depress the lever
towards wheel and move wheel and lever assembly
to desired position. All wheels must be placed in the
same relative position. See Figure 15.
The blade continues to
Never operate your unit
Do not at any time make
the engine
For a healthy lawn, never cut more than one-third
of the total length of the grass at any one cutting.
Lawn should be cut in the fall as long as there is
growth.
This mower is designed to be operated at full throttle
to give you the best cut and do the most effective job
of bagging the cut grass.
WARNING:
object, stop the engine. Remove wire
from spark plug, thoroughly inspect the
mower for any damage, and repair the
damage before restarting and operating
the mower. Extensive vibration of the
mower during operation is an indication of
damage. The unit should be promptly
inspected and repaired.
USING YOUR MULCHER
(Mulching Kit is Optional Equipment )
For effective mulching, do not cut wet grass
because it tends to stick to the underside of the
deck, preventing proper mulching of grass clippings.
New or thick grass may require a narrower cut. The
ground speed should be adjusted to the condition of
the lawn. If mowing has been delayed and the grass
has been allowed to grow in excess of 4", mulching
is not recommended. Mow using the grass bag (if
so equipped) to reduce the grass height to 3-1/4"
maximum before mulching.
and
12
If you strike a foreign
Height
Adjustment
Lever
Figure 15