Summary of Contents for Graco 248113
- Page 1 Instructions 248113 Transformer Repair Kit 309930C For Transformers used on Reactor™ Proportioners Graco Inc. P.O. Box 1441 Minneapolis, MN 55440-1441 Copyright 2003, Graco Inc. is registered to I.S. EN ISO 9001...
- Page 2 Removal Removal Use F . 1 for the following instruction. WARNING WARNING Repairing this equipment requires access to parts Wait 5 min for stored voltage to discharge (E-30 and which may cause electric shock or other serious injury E-XP2 models only). if work is not performed properly.
-
Page 3: Installation
Installation Installation Use F . 2 for the following instruction. To white terminal block Red wires To circuit board TI5690A . 2: Installation of new harness 1. Install 12-gauge red wires #1750 and #1730 into 8. Insert wires (O, P) into other end of splice and new connector (J). - Page 4 Installation 12. Take larger 8-gauge wires and cut pins from both 16. Install splice between the two wires and tighten sides. screws. Cut wire Male pin Wire Shrink Splice Wire tubing Wire Wire Cut wire Female pin 17. Slide shrink tube over splice. 18.
- Page 5 Installation 309930C...
-
Page 6: Warranty
With the exception of any special, extended, or limited warranty published by Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective.