Table of Contents
Advertisement
Identification via the Service Pin
To identify the node, you can activate the service pin by means of a
reed sensor located inside the unit (see Figure 12). This procedure
consists of the following steps:
1. Place a magnet in front of the service reed sensor (see Figure 14).
2. The TemaServer then sends a wink command in response to the
service pin, which makes yellow LED flash for 2 seconds. This allows
you to verify that communication to and from the TemaServer is
working.
3. Check that the service LED remains off after you have completed
this operation.
ACTIVATION
ACTIVATION
Honeywell
SERVICE
REED SENSOR
Figure 12. Service Elements
RTUA01P
SERVICE LED
Page 23
Hide quick links:
Advertisement
Table of Contents
