KNOW YOUR PRODUCT CONTENTS Know Your Product....................3 Description of Symbols................... 4 Contents of Electric Chainsaw................5 General Safety Instructions..................6 Additional Safety Instructions for Electric Chainsaw..........8 Assembly Instructions....................10 Operation.......................14 Turning On and Off...................14 Safe Use of Electric Chainsaw................ . 14 Tips For Using Your Electric Chainsaw............
DESCRIPTION OF SYMBOLS DESCRIPTION OF SYMBOLS (CONT.) The rating plate on your tool may show symbols. These represent important Disconnect from mains power immediately if the power cord becomes information about the product or instructions on its use. damaged Denotes risk of personal injury, loss of life, or damage to the tool in case of nonobservance This product is double insulated electrically Read the user manual...
GENERAL SAFETY INSTRUCTIONS GENERAL SAFETY INSTRUCTIONS (Cont.) WARNING! Read all instructions. Failure to follow all the instructions listed A wrench in all of the warnings listed below refers to your mains operated (corded) power tool or battery operated (cordless) power tool. injury.
ADDITIONAL SAFETY INSTRUCTIONS FOR ELECTRIC ADDITIONAL SAFETY INSTRUCTIONS FOR ELECTRIC CHAINSAW CHAINSAW (Cont.) Chainsaw safety warnings: Either f these f the saw res t in s the safety saw As a is the res rre t rating r res r r’...
ASSEMBLY INSTRUCTIONS WARNING! Always use a saw chain designed as “low- kickback” or a saw chain which meets the low-kickback Assemble the guide bar and saw chain before operation. Follow the requirements! A standard saw chain (a chain which does operating instructions step-by-step and use the pictures provided as not have the kickback reducing guard links) should only be a visual guide to easily assemble the product.
Page 7
> > Replace the cover (10) and WARNING! Always use a saw chain designed as “low- surface. slightly tighten the retaining nut (9) kickback” or a saw chain which meets the low-kickback > Turn the tension screw (3) clockwise with the wrench (8) (Fig. requirements! A standard saw chain (a chain which does clockwise until the chain “tie straps”...
OPERATION (Cont.) Auto oiling system This chainsaw is equipped with an auto oiling system that keeps the saw chain and Note: Direction of fall (B) is controlled by the notching cut. Before any cuts are made, guide bar constantly lubricated. The oil level window (11) shows the level of the oil consider the location of larger branche s and natural lean of the tree to determinate in the chainsaw.
OPERATION (CONT.) OPERATION (Cont.) Note: The best way to hold a log while bucking is to use a saw horse. When this 2. When diameter of wood being cut is is not possible, the log should be raised and supported by limb stumps or by using greater than the bar length, make 2 supporting logs.
MAINTENANCE The following suggestions deal with the daily maintenance of the chainsaw. In the event of failure contact an authorised service centre. condition. This chainsaw meets all legislation requirements; in order to avoid injures all to the recommended chain oil for use with this chainsaw.
WARRANTY POLICY Mitre 10 or Mitre 10 MEGA store where the product was purchased from, for the warranty to be applicable. Congratulations on your purchase of Electric Chainsaw . In order to get maximum benefit from your new purchase, please be aware of the warranty provisions Please retain your Proof of Purchase.
Need help?
Do you have a question about the YT4334-03 and is the answer not in the manual?
Questions and answers