Zipato PSE02 Manual

Multiple Sound Siren PSE02
The multiple sound siren PSE02 is a wireless siren, based on Z-Wave
technology. It is the Z-Wave
OTA... Those newest features of the Z-Wave
wireless communication protocol designed for home automation,
specifically to remotely control applications in residential and light
commercial environments. The technology uses a low-power RF radio
embedded or retrofitted into home electronics devices and systems,
such as lighting, home access control, entertainment systems and
household appliances.
This product can be included and operated in any Z-Wave
with other Z-Wave TM certified devices from other manufacturers and/or
other applications. All non-battery operated nodes within the network
will act as repeaters regardless of vendor to increase reliability of the
network.
The device adopt the Z-Wave
network system is all made by Z-Wave
network system will have the advantages as below.
TM plus product, it support the security,
TM technology. Z-Wave
TM 500 series chip, when your Z-Wave
TM 500 series devices. The
Concurrent multi-channel support reduces external interference.
•
Better RF range, improve about 10 meters in indoor.
•
Support 100 Kbps transmit speed, speed up communication.
•

Product Overview

TM
TM is a
Adding to Z-Wave
There are one tamper key and a circle button behind the device. Both
TM network
of them can add, remove, reset or association from Z-Wave
In the first time, add the device into the Z-Wave
sure the primary controller is in the add mode. And then power on the
device. The device will auto start the NWI (Network Wide Inclusion)
mode. And it should be included in 5 seconds. You will see the LED
TM
light ON one second.
1
Circle Button
Siren
Battery
(Optional)
TM Network
DC Jack
Tamper Key
TM network.
TM network. First, make