Page 1
User Manual Escape Plus Model: ® ETM-LX-PLUS REV. 2/5/20 13655 Stowe Dr. Poway, CA 92064 P: (858) 679-1191 F: (858) 726-6005 www.mytee.com...
Page 2
Congratulations on the purchase of your new Escape® Plus Electric Truckmount. As technology continues to develop you can work confidently knowing that both Mytee Products and its employees are equally dedicated to developing with the industry and its advances. Like any other piece of machinery or technology, the Escape® Plus also requires proper maintenance and care to keep the product working over extended use.
Table of Contents Important Safety Information At a Glance 1.1 - Technical Specifications 1.2 - Included with the Escape® Plus 1.3 - Escape® Plus Front View 1.4 - Escape® Plus Rear View 1.5 - Escape® Plus Switch Plate Machine Operation 2.1 - Powering the Escape®...
This machine must be grounded. If it should malfunction or When and if calling Mytee for support, please have your break down, grounding provides a path of least resistance Model and Serial Number available for faster assistance.
Page 5
Important Safety Information 3. Always unplug power cord from electrical outlet before attempting any adjustments or repairs. 4. Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord. 5. Do not pull or carry by cord. Do not close a door on cord or pull cord around sharp edges or corners.
1 - At a Glance 1.3 - Escape® Plus Front View 1. Switch Plate (see pg. 9) 7. Recovery Tank Drain Valve 2. 7 qt. Big Mouth™ Bottle 8. Auto Fill Hose Connection 3. Solution Tank Opening 9. Pump-Out Hose Connection 4.
1 - At a Glance 1.5 - Escape® Plus Switch Plate 1. Dual Circuit Indicator Light 4. Solution Hose Connection 5. Wash Out Hose Lights up and plays a tone when cords 1 & 2 are 6. Pressure Regulator plugged in to two separate 115V circuits. 2.
The Escape® Plus runs off a a holding tank to the Escape® Plus solution tank via the minimum of 7,500 watts, however, Mytee recommends auto-fill fitting on the front of the unit. ♦ running the machine off a 12,000 watt generator.
2 - Machine Operation 2.5 - Using the Pump-Out 2.7 - Emptying the Solution and Recovery Tanks Connect the included pump-out hose to the cam lock fitting on the front of the machine. The other end of the The Escape® Plus features tank drain valves on the hose can be placed in a holding tank for recovered water.
Place the side panel off to the side. ♦ 3.2 - System Maintainer Weekly flushing of the solution system with Mytee® System Maintainer helps keep lines clean and prevents chemical build-up, improving pump life, performance and pressure.
4 - Troubleshooting 4.1 - Vacuum Troubleshooting 4.2 - Pump Troubleshooting Vacuum is not turning on. Pump runs but there is no spray. Possible Cause Solution Possible Causes Solutions Vacuum may not be getting Check for faulty connec- Tank is empty. Fill tank.
4 - Troubleshooting 4.3 - Pump-Out Troubleshooting Pump turns on but doesn’t pump out. Possible Causes Solutions Clogged filter. Check filter. Clear any obstructions. Clogged pump. Flush tank and pump-out with clean water to clear debris from lines. Pump doesn’t turn on. Possible Causes Solutions Obstructed float switch.