Ricoh A318 Service Manual page 47

[C]
7. Mount the DF on the DF mounting bracket so that the holes in the DF are
aligned with the pins on the mounting bracket, then slide the DF to the left
as shown.
8. Secure the DF to the DF mounting bracket (4 screws).
9. Secure the 2 stud screws [A] as shown.
10. Install the lift switch actuator [B] (1 screw).
11. Place the bushing [C] on the DF harness as shown in the figure.
12. Place the bushing on the harness bracket [D] and secure the bracket to
the harness support bracket [E] (2 screws).
[A]
[D]
8-27
1 December 1990
[B]
[E]
[D]