Advertisement
Detailed Operation
sTaRT
sTaRT
10
sTOP
sTaRT
24
30
22
Main OPeRaTiOn sCReen
DeTaiLs OF The Main OPeRaTinG sCReen
The POOL TeMPeRaTURe window shows the actual water temperature returning from the pool.
This will vary
slightly to the actual temperature in the pool because for safety reasons the electronic sensor is in the cooling
unit not in the pool.
it accurately reads the actual temperature of the water that is returning to the pool. The
actual pool temperature will be slightly different depending on your particular setup. The temperature is always
accurately maintained but if you want to display the actual pool temperature within 1 degree you can simply set
an offset amount to compensate for the difference when selecting your required temperature.
The heaT PUMP TeMPeRaTURe window shows the temperature inside the cabinet.
if this exceeds 70°C or
158°F the system will shut down,
an alarm will sound and a warning screen will appear. This could happen in
extremely hot conditions or if the unit is covered by an object such as a towel or anything that prevents proper
airflow.
The OUTsiDe TeMPeRaTURe WinDOW shows the current room or outside temperature. it is not desirable
to operate this system in temperatures above 42°C or 108° F. if the reading exceeds this you need to move
the system to a cooler area or improve the air flow. The PReseT TeMPeRaTURe WinDOW always shows
your selected temperature. This is the temperature the water will be automatically cooled (or heated) to and
maintained at.
ChanGinG The TeMPeRaTURe seTTinG
You can change your preset temperature at any time by touching the ChanGe seTTinG BUTTOn, this will take
you to the change settings screen. From here you proceed as described previously.
ChanGinG FROM COOLinG TO heaTinG
if you have the DUaL TeMP model you can also heat your pool up
to 42ºC for contrast therapy, however, for safety reasons you cannot change directly from heating to cooling or
cooling to heating. To do this you must switch off the entire system at the main switch and start again. This is
required to prevent the system from changing modes accidentally.
see seTTinG UP FOR heaTinG MODe on page 7
Fan sPeeDs
During normal operation the main fan will automatically change speeds as required to maintain the highest
efficiency. The fan will be at full speed when temperatures are high or the water is warm.
Advertisement
