Advertisement
Fax +32 2 359 95 50
Then add the melted butter.
Sift the self-rising flour.
Beat the self-rising flour into the mixture.
You can also use other homemade recipes or liquid cake mix AND/OR powdered cake mix.
Preparation:
Prepare the batter as indicated in the recipe or on the packaging of the liquid or powdered
cake mix.
Baking:
Preheat the appliance.
Then pour the batter into the baking forms. The baking forms normally do not have to be
buttered, but if you notice that the cupcakes are hard to remove when they have been
baked, it is advised to grease the baking forms lightly before the next baking process.
Let them bake for 5-7 minutes, not longer so that they remain nice and smooth on the inside.
Please note: the cooking time may vary depending on the type of cake mix used.
TIP: after baking, you can garnish the cupcakes for instance with chocolate sprinkles, sugar
pearls...
CLEANING AND CARE
Before cleaning, put the thermostat in minimum position "0", unplug the appliance and
•
wait for it to cool down.
The extension ring and the silicone baking moulds can be washed in soapy water. Do not
•
use any abrasive scouring pad for the plastic materials. Rinse with clear water and let
them dry before using them again. Do not put them in a dishwasher.
Wipe the outside only with a slightly moistened cloth ensuring that no moisture, oil or
•
grease enters the cooling slots.
Wipe the inside and the edges of the plate with a paper towel or a soft cloth.
•
Do not clean the inside or outside with any abrasive scouring pad or steel wool as this will
•
damage the finish.
Do not immerse in water or any other liquid.
•
UK STYLE PLUG WIRING INSTRUCTIONS (IN THE UK ONLY)
You must only plug the appliance into a 220-240V, 50Hz power supply. Connecting it to other
power sources may damage the appliance.
This product must only be used from a 13 amp power socket. If a BS1363 approved 13 amp
plug is used, it should be fitted with a 13 amp fuse conforming to BS1362 and be ASTA
approved.
IMPORTANT
The wires on the power cord are colour coded:
blue = neutral, brown = live, green or green & yellow = earth.
The blue wire must be connected to the terminal marked N or coloured in black.
The brown wire must be connected to the terminal marked L or coloured in red.
The green (& yellow) wire must be connected to the terminal marked E or coloured in green (&
yellow).
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
7
Assembly page 7/8
TKG MOV 1001 - 141105
Advertisement
