Advertisement
5. Close the door and lay the assembly on its back to install the casters. The two locking casters should be installed in
the front by the door for ease of access when locking and unlocking. Each caster has a large hole and a small hole.
The small hole should be positioned inside the cabinet. Line up the holes in the cabinet sides with the holes in the
casters and insert the caster screw through the large
hole of the caster, through the cabinet and screw into
the small hole of the caster. Tighten the screw until it
is snug.
6. Lift the cabinet and set it upright on its casters.
7. Unpack the top, holding the leaf and top together for easier handling until the next step.
8. With help, let the leaf hang freely, lining up the cam bolts with the cam locks that have been factory installed in the
cabinet, lower the top onto the base. When the top lays flat on the cabinet, tighten the six cam locks using the #2
Phillips screwdriver by turning each one approximately 180 degrees or until snug.
9. Secure the lift to the top using two 5/8" wood screws through the lift's top plate to the cabinet top.
10. Restore the drawers to their original locations.
11. If purchased, install the module rack on the left outside wall referring to the instructions that come with it.
njoy your new sewing cabinet!
E
Instructions_8300.odt
12/02/14
Pg. 2 of 2
Advertisement
