Page 2
AUTOCLAVE PRIMA 1. Please unpack the Prima Autoclave. 1 › 2 › 3 › r out r out wate wate Distil Distil wate r in wate r in Distil Distil r out r out Used wate Used wate flow port...
Page 3
QUANTITY RACK (FOR TRAYS) 1 PIECE TRAYS 4 SET DRAINAGE PIPE 2 PIECES GASKET 1 PIECE INSTRUMENT FOR TRAYS 1 PIECE USER MANUAL 1 PIECE DOOR KEY FOR DOOR REGULATION 1 PIECE USB KEY 1 PIECE SPACERS 2 PIECE PRIMA...
Page 4
4. Please place the sterilizer on a flat surface area and raise the front-end part 3.5 cm higher than the back-end as illustrated below: minimum 5° upwards 3.5 cm 5. To regulate the incline of this sterilizer, Figure 1 please unscrew the nut with the 17 mm key. Please regulate the base and tighten the nut with 17 mm.
Page 5
Figure 4 8. Please connect the drain pressure pipe (Connector 1) and the used water pipe (Connector 2) to the available exhaust system through the specific connectors. (Figure 4) Please remove all accessories from the chamber before switching Connector 1 Connector 2 the machine on.
Page 6
Figure 6 A. DATE AND TIME SETTING: Temp. Please turn on Setting Mode and keep pressing together to °C “PROG” and “TEST” for about 8 seconds. (Button 3) (Button 1) Press. The following graphics will appear on the screen: (Figure 6) - i - Please push PROG.
Page 7
C. ALTITUDE SETTING: - Please press together START + TEST (Button 2) (Button 1) for about 8 seconds. - T1 function will appear on the screen (Figure 8a) - Please press PROG. for 6 times until “ALT” (Button 3) function appears on the screen. - Please press TEST or START (Button 1)
Page 8
G. At the end of the cycle, please check if the report is correctly printed and it is saved on USB. FOR FURTHER INFORMATION ABOUT THE TECHNICAL INSTALLATION, PLEASE READ THE TECHNICAL MANUAL ISSUED. Via Umbria 10 20090 Segrate Milano ITALIA info@galbiati.com www.galbiati.com...
Need help?
Do you have a question about the PRIMA and is the answer not in the manual?
Questions and answers