EX- A1
I / O E x p a n s i o n M o d u l e Ad a p t e r
Mounting the EX-A1
Mounting Considerations
DIN-rail mounting
Snap the EX-A1 onto the DIN rail as shown below; the EX-A1 will be squarely situated on the DIN rail.
Screw-Mounting
The figure on the next page is drawn to scale. It may be used as a guide for screw-mounting the EX-A1.
Mounting screw type: either M3 or NC6-32.
2
Do not install in areas with: excessive or conductive dust,
corrosive or flammable gas, moisture or rain, excessive heat,
regular impact shocks or excessive vibration.
Provide proper ventilation by leaving a minimum space of 10mm
between the top and bottom edges of the device and the
enclosure walls.
Do not place in water or let water leak onto the unit.
Do not allow debris to fall inside the unit during installation.
80mm
Unitronics Industrial Automation Systems
1 2 / 0 1