Samsung SH24TAB5 Service Manual page 26

Troubleshooting
5-3-2 Set up the Model option
The Method for Setting up the model option with remocon
¥ It is necessary to set up option code after replacing the main-PAB as a service parts.
Make sure that you can set up the option of code the remote controller after you replace the main
PBA otherwise, the unit wonÕt be working properly and all LED lamps on display will be flickering.
Step 1 : Preparing the remocon to main PBA option set
1 st Remove the battery from the remocon.
2 nd Press the temperature raise/down button simultaneously
and insert the battery again.
3 Make sure the remocon display shown as
rd
Step 2 : Second stage preparation of the remocon option set.
Note ; In case the wrong letter has been selected, continue to press the button until the correct letter appears.
1 st If the first stage number Ò Ó appears on the display, proceed to the second stage.
Every time the ! and & button, Ò Ó and Ò
2 nd
Whenever pressing the @, #, $, %, ^, *, (, ), 1, 2 button, the number increase from
3 rd
0~9(0123456789) and A, b, C, d, E, F each time.
5-8
Ó each continue to appear.
! If the first number is
appear.
@ When pressing the
select one of them.
# When pressing the
select one of them.
$ When pressing the
select one of them.
% When pressing the
select one of them.
^ When pressing the
select one of them.
.
, it is correct otherwise press
button ~ appear on the display,
button ~ appear on the display,
button ~ appear on the display,
button ~ appear on the display,
button ~ appear on the display,
Samsung Electronics
until