Prime TWINDOSE 20 Instruction Manual page 4

1.4

pressure for the rinse pump.
GETTING
STARTED


Installation
Application of incorrect voltage will permanently damage the unit and is not covered
under warranty. Avoid wiring to any power source that has large fluctuations in voltage
Set Up &
and/or is prone to surges. Refer to the wiring diagram in this manual for all power and
Operation
signal connections.

Maintenance &
the three available input voltages (24 - 115 - 230 Vac) of the transformer inside the
Accessories
TWINDOSE 20.

Troubleshooting
disconnect power when servicing the unit.

Contacting SEKO
warewasher.

persons or things or the incorrect functioning and damage to parts of the equipment.
TWINDOSE 20
WARNINGS
Check pressure at the rinse injection point in respect of the max-recommended
Check suction tubes are inserted in the correct product tanks (supply containers).
All electrical connections to the TWINDOSE 20 should first be verified with a meter.
Check the voltage of the main power source and make sure that it matches one of
CAUTION: The TWINDOSE 20 has high voltage connected to the transformer. Always
CAUTION: During installation and electrical connections remove all power from the
Non-compliance to any of the dispositions hereby contained may cause damage to
Rev. 1.4 cod. 0000136325 3