Warnings; Error Signals - Cardin Elettronica ZVL414.04 Manual

• Inserting a code with more than 6 digits will cancel the operation in progress.
Signal: the keyboard will emit a beep.
• The available time between inserting one digit and the next is 5 seconds.
Once the time has expired the operation will be cancelled.
• "Code memorisation": once the code has been memorised the device will automatically quit the procedure after 20
seconds has elapsed.
Signal: the red LED will flash on the keyboard and 6 consecutive beeps will sound

Warnings

• Before memorising the transmitters for the first time remember to cancel the entire memory content.
• Only one remote code memorising access code can be stored.
To change it you need only repeat the procedure and save the new code.
• Cancelling the entire memory content will also cancel the remote code memorising access code.
• After 5 attempts to insert and incorrect code (doesn't exist in memory) the system will remain blocked for 60 sec-
onds.
Signal: the keyboard will sound 1 beep and both LEDS will flash for 5 seconds.

Error signals

Interface - the red LED flashes:
- memory full (attempt to memorise has failed)
- code doesn't exist (during memorisation)
- code doesn't exist (during cancellation)
Keyboard - the red LED flashes:
- together with three slow beeps, code doesn't exist (during memorisation)
- code doesn't exist (during cancellation)
- together with three fast beeps, code doesn't exist in the operating mode.
NOTES
19