Operating Test - Aardenburg BETA M Series Operation & Service Manual

7.0 Machine maintenance
7.6 OPERATING TEST AFTER MAINTENANCE
It is good practice to test the machine to make sure it operates properly, and that work was done properly after
performing any maintenance and/or repairs on the machine.
Proceed as follows:
1. Connect the machine to the tractor if necessary (see paragraphs 5.2 and 5.4);
2. Make sure the machine is resting on the levelling roller but is high enough
so that the tools do not touch the ground;
3. Check that there are no extraneous persons within a 10 m range of the machine;
4. Engage the P.T.O. and gradually accelerate until you reach the 540 RPM operating speed;
Check the tools if the machine vibrates during the test (see paragraphs 7.5.1 and 7.5.2).
The rotor will need to be dynamically balanced if the machine vibrates after the tools are checked or replaced.
In this case turn to your local retailer.
Aardenburg Machinery BV. ALPHA BETA M (door) 20