Drum Description Starting Quantity - JOBO 3012 Manual

Too low a water level may cause the temperature tolerance to fluctuate and
too high a water level may cause uneven processing (the drum will not be
level if it floats off the rollers).
' Required solution levels will vary with different film types and processes.
Use the following amounts as a starting point:

Drum Description Starting Quantity

3027 11 x 14" Sheet Film Drum 400ml
3028 16 x 2O" Sheet Film Drum 600ml
If results are unsatisfactory (particularly if uneven or underdeveloped) try increasing the
solution amount.
NOTE: CPP-2 and CPA-2 Processors and Lifts can be damaged by excessive weight
loads. When using the lift, be sure to use both hands to raise the drum when draining.
Check the actual rotation speed of the drum; due to the weight, it might be necessary to
slightly increase the rotation motor speed on the ATL-1, CPP-2, and CPA-2 Processors.
possible repair.
Back to Top