Post Processing; Cleaning The Drum; Drying The Drum - JOBO 3012 Manual

3004 8 X 10" 270 400 600 800
3004 8 1/2 X 12" 270 480 720 960
3005 5 X 7" 270 270 270 340
3005 8 X 10" 270 400 600 800 1000
3006 4 X 5" 210 210 210 210
3006 5 X 7" 210 210 255 340
3010 4 X 5" 210 210 210 210
Back to Top

Post Processing

1.
Uncouple the Drum from the lift arm and drain the water jacket from the Drum bottom into the processor trough.
2. Remove the lid from the Drum.
3. Fill the individual cylinders with water to remove the film safely.
Back to Top

Cleaning the Drum

Important! - After each process thoroughly clean the Drum and the lid with warm water (not over 122 F or 50 C).
Back to Top

Drying the Drum

For drying the Drum use the drying rod #3007 for Drum #3006, or #3008 for Drums #3004, 3005 or 3010. The sponge
on the end of the rod must be moistened first. Do not exceed 122 F (50 C). The Drum lid should be thoroughly rinsed
with water. The light trap is permanently attached to the lid. The bottom of the lid should be rapped sharply against a
towel laid on a flat surface. This will dislodge water droplets from behind the light trap. The lid should then be toweled
dry.
Water droplets "hiding" in the lid can cause spots or drip marks on your film.
Back to Top
425
250 300
425 510
250 300 350 400 450 500