Advertisement
4.
OPERATING INSTRUCTIONS
4.1.
Insert the chisel shank into the gun cylinder (fig 3).
4.2.
Place the retainer ring over the chisel (fig 3) and lower onto the hammer's cylinder thread.
Wind the retainer spring on to the cylinder using a clockwise motion until the spring is fully
located and the chisel is retained by the spring's retaining tag (fig 4).
4.3.
To remove attachment reverse procedures 4.1 to 4.2.
4.4.
Connect the tool to the air supply as described in Section 3.
4.5.
To operate the hammer, squeeze the trigger taking care that the chisel end is not in contact
with the workpiece.
5.
MAINTENANCE
DO NOT allow hammer to free run for an extended period of time as this will shorten its life.
WARNING! Disconnect hammer from air supply before changing accessories, servicing or
performing maintenance. Replace or repair damaged parts. Use genuine parts only.
Unauthorised parts may be dangerous and will invalidate the warranty.
5.1.
If the air system does not have an oiler lubricate the air hammer daily with a few drops of
Sealey air tool oil dripped into the air inlet.
5.2.
Clean the hammer after use. DO NOT use worn, or damaged chisels.
5.3.
Loss of power or erratic action may be due to the following:
a) Excessive drain on the air line. Moisture or restrictionin the air pipe. Incorrect size or type
of hose connectors. To remedy, check the air supply and follow instructions in Section 3.
b) Grit or gum deposits in the hammer may also reduce performance. Flush the hammer
out with gum solvent or an equal mixture of SAE10 oil and paraffin. Allow to dry before
use.
5.4.
For a full service contact your Sealey agent.
5.5.
When not in use, disconnect from air supply, clean hammer and store in a safe, dry,
childproof location.
Risk of Hand Arm Vibration Injury
Air Hammer, model no. SA613 when operated in accordance with these instructions and tested in
accordance with BS EN ISO 28927-10:2011 results in the following vibration emission declared in
accordance with
BS EN12096: 1996.
Measured vibration emission value: . . . . . . . . . . . . . 2.5m/s²
Uncertainty: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.0m/s²
These values are suitable for comparison with emission levels of other tools that have been subject
to the same test. This tool may cause hand-arm vibration syndrome if its use is inadequately
managed. Recommended Measures to reduce risk of hand-arm vibration syndrome:
This duration of use should be reduced if the individual is exposed to hand-arm vibration from other
sources.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
fig 3
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version
fig 4
01284 757500
Web
01284 703534
email
www.sealey.co.uk
sales@sealey.co.uk
SA613
Issue: 1 - 07/09/11
Advertisement
