Advertisement
2.
SPECIFICATIONS & INTRODUCTION
Chisel Shank Size: . . .401" Parker Taper
Speed: . . . . . . . . . . . . . . . . . . . 3700bpm
Stroke . . . . . . . . . . . . . . . . . . . . . . . 50mm
Air Consumption: . . . . . . . . . . . . . . . 7cfm
Operating Pressure: . . . . . . . . . . . . .90psi
Air Inlet Size: . . . . . . . . . . . . . . . . ¼"BSP
Weight: . . . . . . . . . . . . . . . . . . . . . 1.36kg
Sound Pressure . . . . . . . . . . . 100.3dB(A)
Vibration . . . . . . . . . . . . . . . . . . . . 2.5m/s
Almost half the vibration level of a traditional low cost air hammer. Composite lightweight
housing reduces effects of chill on operator's hands for added comfort. Exhaust outlet
adjusts 360° keeping airflow away from operator. Heat treated alloy steel impact
components ensures suitability for the professional workshop. Supplied in storage case
with five chisels.
3.
PREPARING TOOL FOR USE
3.1.
Air Supply
WARNING! Ensure the air supply is clean and does not exceed 90psi while operating the
hammer. Too high an air pressure and unclean air will shorten the product life due to
excessive wear, and may be dangerous causing damage and/or personal injury.
3.1.1. Ensure hammer air valve (or trigger) is in the "off" position before connecting to the air
supply.
3.1.2. You will require an air pressure of 90psi, and an air flow according to specification.
3.1.3. Drain the air tank daily. Water in the air line will damage the hammer.
3.1.4. Clean air inlet filter weekly.
3.1.5. Line pressure should be increased to compensate for unusually long air hoses (over 8
metres). The minimum hose diameter should be 1/4" internal diameter and fittings must
have compatible dimensions.
3.1.6. Keep hose away from heat, oil and sharp edges. Check hose for wear, and make certain
that all connections are secure.
3.2.
Couplings
Vibration may cause failure if a quick change coupling is connected directly to the wrench.
To overcome this, connect a leader hose to the air hammer (Sealey ref: AH2R or
AH2R/38). A quick change coupling may then be used to connect the leader hose to the
air line recoil hose. See fig 1 & fig 2.
fig 1
2
Original Language Version
fig 2
SA613
Issue: 1 - 07/09/11
Advertisement
