Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Sunquest SQ 1000S
Summary of Contents for Sunquest SQ 1000S
- Page 1 ¨ S S E M B L Y S E R U I D E M O D E L 1 0 0 0 S 21160A...
- Page 2 Warranty What Is Covered? SunQuest warrants your tanning unit to be free of structural defects in its material and workmanship, under normal use, for its lifetime. SunQuest will repair or replace, at their discretion, any defect to the structure which affects the performance of the unit.
-
Page 3: Table Of Contents
elcome Congratulations on your purchase of this technologically advanced sun tanning unit. It has been designed to provide years of dependable service for you. Please read all the instructions in this booklet before installing and using the unit. Always be sure to observe all safety precautions. ontents Safety Information................ -
Page 4: Safety Information
afety Information LABELING NOTICE: Labels are affixed on all systems to inform the user of possible dangers. Regulations are stated in 21 CFR, Section 1040.20, and require that all products manufactured after September 8, 1986 which use sunlamps must display the following: Ultraviolet radiation. -
Page 5: Installation
nstallation Unpacking and Inspection Your sun canopy comes packed in a single cardboard carton fully assembled. The carton contains the following: • Sun canopy • Assembly and User Guide • Safety eyewear Inspect these items making sure they are free from any visible damage. Report the extent of any damage to the transportation company. -
Page 6: Pre-Installation Planning
Installation-Pre-Installation Planning Pre-Installation Planning Before you begin to assemble your sun canopy, you should observe the following pre-installation considerations. • Your sun canopy operates from a 120V ac source. You should have a standard NEMA 5-15R electrical outlet (like the type shown below) installed in the room in which you will use the canopy. -
Page 7: Transporting
Installation-Transporting Transporting Your sun canopy comes with a handling strap attached on the swivel arm, this strap should be used when transporting the sun canopy. • Lower the sun canopy to its fully closed position by pressing down on the swivel arm. Note! Resist pressing down on the canopy itself when possible, as this action causes added stress to the canopy structure. -
Page 8: Operation
peration Before You Tan Before using your sun canopy, please note the following important precautions: • Your skin should be free of cosmetics, tanning oils, or other body lotions prior to tanning except for those specifically made for use with tanning devices. -
Page 9: Using Your Sun Canopy
Operation-Using Your Sun Canopy Using Your Sun Canopy Once you have read Before You Tan and Exposure Times (located on page 4), you are ready to use your sun canopy. Proceed as follows. WARNING! Your sunbed is designed for individual use. Only one pair of protective goggles is provided. -
Page 10: Care And Maintenance
are & Maintenance Thorough Periodic Cleaning Introduction The cooling fan draws air through the canopy and over time will cause a dust build- up on the lamps and reflectors. This will reduce the tanning effectiveness of the bed. When a dust buildup is observed, it is necessary to thoroughly clean the inside of the canopy. -
Page 11: Replacing Lamps
To re-install a lamp, insert the pins located on the ends of the lamp into the slots on top of the lamp holder and turn the lamp 90 degrees. Only the following lamp types have been certified for use in SunQuest Sun Canopies Application Lamp Model Number Canopy... -
Page 12: Timer Maintenance
Care & Maintenance-Timer Maintenance Timer Maintenance Your SunQuest sun canopy is equipped with a backup shut-off timer which will automatically turn off the sun canopy in the unlikely event of a malfunction of the primary timer. This important safety feature also prevents the user from re-setting the timer before the end of the pre-set maximum time interval. -
Page 13: Troubleshooting
roubleshooting Problem/Solution Chart Problem Solution Lamps fail to light 1. Check source of ac power. Reset circuit breaker or replace fuse if necessary. 2. Make sure the unit is plugged into outlet. 1. Check that lamp is installed correctly. 2. Switch unlit lamp with a lamp that lights. If the One or more lamps fail new lamp lights and the old lamp still does not, to light... - Page 14 NOTES...
-
Page 15: Obtaining Service
6270 Corporate Drive Indianapolis, IN 46278-2900 Have the following information ready when calling ETS to order parts or service for your canopy: Date Purchased Canopy Serial Number Manufactured for SunQuest by: Spectrum Products, Inc. 6220 Churchman Bypass Indianapolis, Indiana 46203...
Need help?
Do you have a question about the SQ 1000S and is the answer not in the manual?
Questions and answers