Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Inter-fab i-Lift
Summary of Contents for Inter-fab i-Lift
-
Page 2: Shipping Information
You have purchased a i-Lift assisted access lift. Providing the unit is installed correctly and properly maintained, it will furnish you with many years of trouble free use. It is important to read this entire manual prior to beginning assembly or operation. -
Page 3: Components And Hardware
COMPONENTS AND HARDWARE 1.800.737.5386 • www.Inter-Fab.com... -
Page 4: Installation Overview
The i-Lift anchor centerline must be no less than 6”, but no greater than 22” from the pool/spa wall (or any feature that sticks out past the pool/spa wall, such as a coping). The i-Lift is installed in a single 2.375” I.D. anchor. -
Page 5: Assembly Instruction
Use a carpenter’s level, to level the anchor making sure that the i-Lift mast will be vertically straight - up and down (perpendicular to the deck) in all directions. It is important that the mast be vertically straight to ensure ease of rotation when the lift is fully loaded. - Page 6 Join the seat arm to the mast assembly using: 2 - 3/8” Shoulder 2 1/2” x 5/16” Thread 4 - 3/8” Flat washers 2 - 5/16” - 16 Nylock nut 4 - Donut Shims 1.800.737.5386 • www.Inter-Fab.com...
- Page 7 1 - 3/8" Nylock Nut Tighten the bolt until the flat washers are snug, and then back off until the Footrest pivots freely. Adjust footrest to desired height using installed 3/8" - Button Head Bolt. Test the lift for proper operation. 1.800.737.5386 • www.Inter-Fab.com...
-
Page 8: Lift Operation
After weight is taken off of the seat, the lift will resume normal operation. If this happens check the lift and pivots for structural damage before resuming a safe lifting procedure at or under the 350# working load limit. 1.800.737.5386 • www.Inter-Fab.com... - Page 9 If the lift does not work with the new transmitter, try the procedure again; making sure that the transmitter is unlocked. If you are not able to program the new Transmitter to your lift, please call Inter-Fab Customer Service at 1-800-737-5386 ext 121.
-
Page 10: Care And Maintenance
When the battery is fully charged, remove it from the battery charger and install the battery on the i-Lift. The Battery Capacity Indicator on the receiver will show a green LED, indicating that the battery is fully charged and installed properly. When the LED changes to amber the lift is still OK to use. However when the LED changes to red, or an audible tone is heard during a lift cycle, the battery pack needs to be recharged. -
Page 11: Troubleshooting
Replace Charger Fuse Bad Battery (red LED on Replace Battery* charger – not turning orange or green in 4 hours or less) * Please contact your local distributor or Inter-Fab Customer Service to order parts 1-800-737-5386 x121 1.800.737.5386 • www.Inter-Fab.com...
Need help?
Do you have a question about the i-Lift and is the answer not in the manual?
Questions and answers