Advertisement
Installation (continued)
3
Remove the
mounting plate
NOTE: The mounting plate (D) comes
pre-assembled on the light fixture (A) for
shipping.
NOTE: The mounting plate tightening bolt
(C) comes pre-installed on the light fixture.
☐
Remove the mounting plate (D)
from the back of the fixture by
loosening the mounting plate
tightening bolt (C) using the allen
key (DD).
TIP: Only unscrew the tightening bolt (C) far
enough to remove the mounting plate (D).
Do not fully remove the tightening bolt (C).
4
Installing the
mounting plate
☐
Route the junction box wires
through the large center hole in the
mounting plate (D).
☐
Align the holes on the mounting
bracket (D) with the holes on your
junction box. Use two #8 screws
(AA), depending on the size of the
holes in your junction box, attach
the mounting bracket (D) to your
junction box.
Visit www.probrite.com/install for installation video tutorials and product support
D
C
DD
AA
D
6
Installation (continued)
5
Making the electrical
connections
☐
If necessary, strip 3/8" of insulation from
junction box or fixture (A) wires (fig 1).
ON/OFF Wiring (Non Dimming) Method:
☐
Connect fixture black wire to house black
wire, the (+) line, and fixture white wire
to house white wire, the (-) common by
twisting the exposed wires together and
using the wire nuts (BB). Ensure no loose
wires.
☐
Connect house ground wire to the green
fixture ground wire, by twisting the
exposed wires together and using the
wire nuts (BB).
0-10V Dimmable Wiring Method:
☐
Connect fixture black wire to house
black wire, the (+) line, and fixture
white wire to house white wire, the (-)
common by twisting the exposed wires
together and using the wire nuts (BB).
Ensure no loose wires.
☐
Connect house ground wire to the
green fixture ground wire, by twisting
the exposed wires together and using
the wire nuts (BB).
☐
Connect the purple wire to the (V+)
DIM wire and the gray wire with (V-)
DIM wire by twisting the exposed wire
together and using the wire nuts (BB).
Please call 1-844-507-5651 or email support@probrite.com for further assistance.
(fig 1).
BB
D
(+) LINE
BLACK
LIGHTING
(-) COMMON
WHITE
FIXTURE
GROUND
GREEN
(Non-Dimming Wiring Diagram)
(+) LINE
BLACK
(-) COMMON
WHITE
(+)DIM V+
PURPLE
LIGHTING
FIXTURE
(-)DIM V-
GRAY
GROUND
GREEN
(0-10V Dimming Wiring Diagram)
TIP: Hold stripped ends near each other and
align any frayed strands (do not twist wires).
Push the wires into wire nut (BB) and use your
fingers to twist the wire nut clockwise until tight.
Check for tightness by pulling wires.
7
PROBRITE.COM
A
Advertisement
