INSTALLATION
How to install
1.
Install refrigerator in a convenient location away from
•
extreme heat and cold.
Allow sufficient clearance between the refrigerator's
•
back, also the side wall, so the door can open fully and
to minimize noise. This refrigerator is not designed for a
recessed installation.
Leveling
2.
Level the refrigerator so that it rests solidly on the floor
•
without rocking.
Leveling legs located near each front corner of the
•
refrigerator are adjustable. Turn to raise or lower them.
If necessary, shim under the rear corner.
3.
Attach the ground wire
(Green/yellow color wire located at the lower left portion
at the back of the refrigerator) to any metal pipe or to a
cover screw of the wall receptacle or to a rod buried at
least 2.4 meters. in the ground.
4.
Keep away from heat or direct sunlight
Place your refrigerator away from any heat source and
•
out of the direct sunlight.
High surrounding temperature will lower cooling efficiency
•
and increase your electricity bill.
5.
Keep away from water and moisture
Place the refrigerator in an area with low moisture.
•
Splashing water or a high moisture area may cause
a short circuit or rusting.
Installation
30 cm.
10 cm.
15 cm.
Refrigerator
Unit
2.4 meters
Ground Wire
5