Table of Contents
Advertisement
NME–3
Installation instructions
Handsfree Microphone HFM–15 and Handsfree Speaker HFS–10
The safest and easiest way to have call while driving is use the handsfree
option. The system consist of two components, the microphone HFM–15
and loudspeaker HFS–10.
The microphone needs to be as close to the drivers mouth as possible
and attached to a surface that is mechanically quiet. The microphone con-
nects to the system cable MIC molex connector but avoids the fan output
area in order to maintain the quality of audio.
The loudspeaker should be mounted at least 3 ft/1 m away from the
handsfree microphone to avoid acoustic feedback. The loudspeaker con-
nects to the system cable SPEAKER molex connector.
External Mobile Antenna (not supplied)
The phone is designed to operate with a high quality external antenna.
However, due to many different types of antennas being available, an an-
tenna is NOT included as part of car kits. Please, consult the dealer to find
out which is the most suitable antenna type for your installation.
Installation
There are some important aspects that require special attention in posi-
tioning mobile phone accessories.
The positioning of the handset holder is the most important factor when
trying to achieve the most comfortable position for the user. The location
of the holder should be selected so that the visibility of the handset's dis-
play is good under all lighting conditions, but not so that the driver's atten-
tion is easily distracted. The holder should be located so that the driver
can easily reach the keypad. Under no circumstances should the holder
prevent the driver from controlling or operating the vehicle in any way or
observing traffic.
The phone mounting bracket may be installed in a variety of places includ-
ing:
. centre console below dash on either left or right side
. any available shelf above or below dash
. vacant DIN slot (consumes only half the height of a DIN slot)
. under seats
. trunk
Ensure the location does not subject the phone to moisture or mechanical
pressure or where there isn't adequate amount of air for cooling (under
the carpet, etc.).
Page 6
PAMS
Technical Documentation
Issue 1 10/99
Advertisement
Table of Contents
