LocknCharge Wall Cage 10 User Instructions page 4

LocknCharge Wall Cage 10
STEP 4.
Now mark two marks on the horizontal line
390mm apart. These are the locations for the
two top Dynabolts. Drill the holes using your
hammer drill and the 10mm masonry bit.
STEP 5.
Knock the two top Dynabolts into the holes using
your hammer and tighten the Dynabolt nuts
slightly to secure the bolts, and remove the nuts
leaving the exposed thread. Locate the Wall Cage
on the top two Dynabolts and replace the nuts.
Hand tighten the nuts to secure the cage for a
moment.
STEP 6.
Mark the wall through the bottom two holes in
the cage and either drill the holes with cage in
place or remove the cage and drill the two holes
where you have marked the wall. Locate the
bottom two Dynabolts in these bottom holes.
STEP 7.
Replace all of the Dynabolt nuts ONE AT A TIME
so that the cage is safely secured to the wall with
the supplied M8 sheer nuts - cone facing the wall
and M8 washers. Tighten the sheer nuts firmly
until the hex head breaks off. This ensures secure
placement of the Wall Cage.