40-INCH EXERCISE TRAMPOLINE WITH HANDRAIL MODEL# 9005MTH PRODUCT MANUAL - VERSION 2.19.1 FOR AGES: WEIGHT LIMIT: TO BUILD: TOOLS NEEDED: 114 Kgs Manual en español ubicado en GQBrands.com Spanish Manual located at GQBrands.com CUSTOMER SERVICE GQBrands.com • CustomerService@GQBrands.com • 1-866-498-5269 • 4401 Samuell Blvd, Ste 150, Mesquite, TX 75149...
CUSTOMER SERVICE INFORMATION Thank you for purchasing: 40-INCH EXERCISE TRAMPOLINE WITH HANDRAIL MODEL# 9005MTH To order these parts, or if you have any other questions or concerns If you have an issue with your item, do not return. Please report...
Page 3
• AVOID bouncing too high. areas such as schools, parks, day Maintain safe control at all times. cares, commercial/communal • DO NOT wear glasses or helmets gyms, etc. when using the trampoline. MODEL# 9005MTH...
PARTS LIST Frame Pad Jump Mat 4A - Top Rail Top Rail Cap Spring 8R - 7A - Handrail Cap Leg Tube Handrail Support Left (A) Handrail Support Right (B) Handrail Foam 6A - Leg Cap GQBrands.com CustomerService@GQBrands.com 1-866-498-5269...
Page 5
Top Handrail Female Top Handrail Male 9A - 11 - 12 - 13 - Top Handrail Foam M6 x 45mm Bolt Nut Cap 16 - 14 - 15 - T-Section Leg Tube M6 x 70mm Bolt Wrench Washer MODEL# 9005MTH...
ASSEMBLY INSTRUCTIONS STEP 1: Parts: (4A) Part 2 (x1) - Frame Pad Part 3 (x1) - Jump Mat Part 4 (x1) - Top Rail Part 4A (x4) - Top Rail Cap (4A) Part 5 (x36) - Spring NOTE: Parts 2, 3, 4, 4A, and 5 might come pre assembled for your convenience.
Page 7
Legs are facing the same direction. NOTE: All bolts must be inserted from the top square openings of the T-Section so the (11) flatheads are under the frame pad. Failure to do this might result in injury if installed incorrectly. MODEL# 9005MTH...
Page 8
ASSEMBLY INSTRUCTIONS STEP 6: Once both T-Sections are secure to the Top Rail, flatten the Frame Pad so all the Springs are covered. Make sure the smaller opening aligns with the side opening of the T-Section. STEP 7: (7B) Parts: (7B) Part 7L (x1) - Handrail Support Left (A) Part 8R (x1) - Handrail Support Right (B)
Page 9
Handrail Support Left (Part 7L). Insert 1x M5x65mm Bolt (Part 15) from the outside of the trampoline, and secure with 1x Washer (Part X1), 1x Nut (Part 12), and (13) (12) 1x Nut Cap (Part 13). (X1) MODEL# 9005MTH...
Page 10
ASSEMBLY INSTRUCTIONS STEP 9: Parts: Part 15 (x1) - M5 x 65mm Part 12 (x1) - Nut Part 13 (x1) - Nut Cap Part X1 (X1) - Washer (15) Locate the smaller opening on the Frame Pad, and align with the bottom opening of the Handrail Support Right (Part 8R).
Page 11
NOTE: Both buttons on the Top Handrails must be inserted in the same parallel openings from both Handrail Supports. Failure to do this might result in breakage of the product or injury when the trampoline is in use. MODEL# 9005MTH...
ASSEMBLY INSTRUCTIONS STEP 13: Guide the Snap Button from the Top Handrail Male (Part 10) into the opening of Top Handrail Female (Part 9) Once the Snap Button is secure, slide the Handrail foams to each other to avoid pinching when using and holding on to Handrail.
Need help?
Do you have a question about the 9005MTH and is the answer not in the manual?
Questions and answers