DISCLAIMER MAKINEX and its affiliates take no responsibility for any damage, injury or death resulting from the incorrect or unsafe use of this product. Use of this product should be undertaken by competent persons only. It is the operator’s responsibility to ensure that the following safety procedures are followed.
PROHIBITED These safety warnings do not eliminate all possible hazards that could occur therefore it is essential to use common sense and to strictly follow any instructions to prevent accidents. JHT-U-2 – User Manual REV0919 Page 2 of 15...
WARNING Exhaust gases from this product contain chemicals known to State of California to cause cancer, birth defects or other reproductive harm. WARNING WASH HANDS AFTER HANDLING THIS PRODUCT JHT-U-2 – User Manual REV0919 Page 3 of 15...
There is a safety and information panel provided on the front of the Jackhammer Trolley to alert the user of potential safety risks/hazards. Please read and adhere to all instructions on the Unit. JHT-U-2 – User Manual REV0919 Page 4 of 15...
Do not operate the Jackhammer without wearing the appropriate personal protective equipment and assessing the surrounding area for hazards. WARNING FITTING A JACKHAMMER Tools Required ▪ 17mm spanner ▪ 2mm allen key ▪ 19mm spanner ▪ Pliers JHT-U-2 – User Manual REV0919 Page 5 of 15...
Page 8
PRODUCT BREAKDOWN Block Set to suit Jackhammer brand provided. See Appendix A for Universal Block Set (JHTB-U-2) assembly. Jackhammer sold separately Step 1: JHT-U-2 – User Manual REV0919 Page 6 of 15...
Page 9
Step 2: Step 3: JHT-U-2 – User Manual REV0919 Page 7 of 15...
1. Ensure cable is not kinked anywhere along its length. 2. Tighten retaining screw with pliers. 3. Tighten adjustment screw with 2mm allen key to remove slack from the cable. NOTE: Some slack in the mechanism is normal. JHT-U-2 – User Manual REV0919 Page 8 of 15...
▪ Adjust brake lever to eliminate free-play. ▪ Lubricate brake lever cable. o Drip light weight oil from the top of the cable so it runs through the cable housing. ▪ Grease the pivot axle. JHT-U-2 – User Manual REV0919 Page 9 of 15...
To take advantage of the MAKINEX limited warranty, you must have maintenance performed by an authorised MAKINEX dealer or MAKINEX service technician. You are free to have your MAKINEX product serviced by any suitably qualified persons and this will not affect your...
Manufacturer. • It is the responsibility (and cost) of MAKINEX or our appointed agent to return the machine to be repaired or replaced under warranty to the consumer- this is valid for domestic territories only (e.g. machine purchased in USA will repaired/replaced under warranty and returned to the USA consumer.
CONTACT INFORMATION For sales, service, warranty and parts for all MAKINEX products; please refer below. SALES, SERVICE, SPARE PARTS & WARRANTY SALES TEL 1300 795 953 or +61 2 9460 8071 WEB www.makinex.com.au AUSTRALIA SERVICE, SPARE PARTS & WARRANTY EMAIL service@makinex.com.au...
APPENDICES A. BLOCK SETS BREAKDOWN B. JACKHAMMER TROLLEY - HAZARD ASSESSMENT APPENDIX A – UNIVERSAL BLOCK SET BREAKDOWN JHT-U-2 – User Manual REV0919 Page 13 of 15...