Advertisement
1
L 230V AC
N
N
L
B
2
A
1 Detach the plastic base (located in the bottom of the luminaire) by pulling the unlock hook and
pass the cables from area
connected to a permanent electrical installation to ensure the immobilization of the cable. Mount
the plastic base with the included mounting accessories.
2 Connect the mains cables to the respective detachable terminal block. Ν for neutral, L for live
wire.
3 Attach the luminaire by sliding it on the plastic base until the plastic hook locks, and power the
Luminaire.
MAINTAINED TO NON MAINTAINED SELECTION CAPABILITY
4 Power on the luminaire and press continuously the TEST button for 10 seconds, until the battery
charging LED blinks and the led strip turns off. The luminaire operates now as non maintained
luminaire. If you want to restore the previous condition (maintained operation), press
continuously the TEST button for 10 seconds, until the battery charging LED blinks and the led
strip lights with less luminosity.
NOTE!! After finishing the installation you must power the device at least for 24 hours for battery charging to perform the nominal
autonomy.
Manufacturer
Model Number
Voltage Range
Nominal Power
Connections
Temperature (tc)
Page 2 of 3
INSTALLATION INSTRUCTIONS
Plastic base
Cable entry hole
or
and through the cable entry hole. The luminaire must be
A
B
LED MODULE CHARACTERISTICS
Cable connection between main pcb and led module
3
GR-151-3/L
Olympia Electronics S.A.
2801101
8.7-10.8VDC
0.59W
45 °C max. across the board
Lock - unlock hook
923151004_09_007
Advertisement
