Kobalt K11RTA-03 Manual page 31

ASSEMBLY INSTRUCTIONS FOR ROUTER TABLE
25. Attaching the Feather Boards
WARNING
• Always unplug the router table before attaching
accessories or making any adjustment.
NOTICE: The front and back side of each feather
board is marked to indicate the proper feed
direction.
Attach the feather board to the fence
a. Place the feather board (U) on the fence
assembly as shown.
b. Insert two round-head, square-neck bolts
through the two holes in the fence and the slots in the feather board.
c. Place a plain washer onto each bolt, then thread the wing nuts onto the bolts and tighten
them to secure the feather board to the fence.
Attach the feather board to the tabletop surface
a. Place the feather board (U) on the tabletop surface.
b. Insert two round-head, square-neck bolts through the holes in the tabletop surface and the
slots in the feather board.
c. Place a plain washer onto each bolt, then thread the wing nuts onto the bolts and tighten
them to secure feather board to the tabletop.
26. Attaching the Table to a Work Surface
WARNING
• Always unplug the router table before attaching
accessories or making any adjustment.
a. Place the router table upright on a sturdy
surface, such as a work stand, workbench, or
countertop.
b. While holding the router table in place, mark
the location of the fastening holes (X) in each
of the legs onto the work surface.
c. Remove the router table.
d. Drill a hole into the work surface at each of the
marked locations.
e. Place the router table on the work surface and align the holes in the table legs with the
holes in the work surface.
f. Secure the router table to the work surface with four bolts and nuts (not included).
g. Tighten the bolts securely.
25
26
31
X
U