Kobalt K11RTA-03 Manual page 28

ASSEMBLY INSTRUCTIONS FOR ROUTER TABLE
21. Attaching the Router to the Table
a. Unplug the router and the router table.
b. Remove the three pan-head screws on the
sub-base (H) to remove it from the router.
c. Place the router upside down so that it is
resting on its top cap and align the hole (3)
with the above-table depth adjustment nut (M)
located on the router. Align the three holes (1)
in the center of the router table surface with the
holes in the router.
d. Insert a flat-head screw (ag) through each of
the three holes in the router table surface and
into the holes in the router base.
e. Hold the router steady with one hand and
securely tighten each flat-head bolt with a
Philips screwdriver with the other hand.
Table: Holes on the tabletop surface
Hole 1 For attaching the router
Hole 2 For attaching the start pin
Hole 3 For above-table depth adjustment
21a
21b
H
21c
28
Hole1
Hole2
Hole3
ag
M