Using The Window Cleaner; After Use; Replacing Components; Technical Data - inventum RR410 Instruction Manual

4

using the window cleaner

7
Use 1 the spray bottle to spray cleaning agent evenly on the surface to be cleaned 2. Use the microfibre cloth 3 to remove
stubborn dirt.
If necessary, wet the microfibre cloth under the tap.
8
Press the on/off switch
of the squeegee are clean before you start.
Move the window cleaner from top to bottom to suck up the cleaning agent and clean your windows without leaving any
streaks.
Instruction: hard to reach places can be cleaned (to a certain extent) with a vertical or horizontal movement.
Instruction: if the battery is almost empty, the indicator light will flash slowly. After a period of time the appliance will switch
off completely once the battery is empty. Charge the battery.
9
Press the on/off switch
in order to extend the time that the battery can be used.
Cleaning windows, mirrors or tiles is also possible without using the spray bottle. Clean your windows in the usual way and use the
window cleaner to suck up the cleaning agent and clean your windows without leaving any streaks.
EMPTYING THE COLLECTION RESERVOIR.
10
Empty the collection reservoir once the amount of dirty water has reached the maximum indication (70 ml). Switch off the
appliance.
Open the lip 1 and allow the collection reservoir to drain empty. Once the collection reservoir is empty, press the lip closed again.
5

after use

9
Press the on/off switch
11
The window cleaner contains electrical components. Do not clean the appliance itself under the tap. Press button 1 to loosen the
squeegee attachment 2.
The squeegee attachment can be cleaned under the tap.
• Remove the microfibre cloth from the holder and rinse it under the tap. The microfibre cloth can be washed in the washing
machine at 30°C. Do not use a fabric softener.
• The basis of the window cleaner may be wiped with a moist cloth.
• Allow all components to dry thoroughly before reassembling the appliance.
• Charge the battery, so that the appliance is ready for future use.
• Store the appliance in a dry room.
6

replacing components

The rubber of the squeegee has a limited life span and we recommend replacing it when it is damaged. The rubber and other
components are available at Inventum.
Slide the old rubber out of the slot and carefully slide the new rubber into the slot of the squeegee. Do not use too much force and do
not pull the rubber.
If placing the new rubber poses problems, you can loosen the screws at the back of the squeegee attachment. Remove the cover and
place the rubber in the slot. Place back the cover and fasten it again with the screws.
7

technical data

Protection factor
Capacity collection reservoir
Maximum battery usage time
Voltage battery
Connected load
Charging time
to switch on the window cleaner. The indicator light switches on. Caution: make sure the rubbers
to switch off the window cleaner. Always switch off the appliance when spraying a surface,
to switch off the window cleaner.
IPX4
70 ml
30 minutes
3.7 V
10 watts
3 hours
Output voltage, charger
Output current, charger
Weight
Work width
Type of battery
5 V
700 mA
650 grammes
280 mm
Lithium
15
English •