Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Meco Smart Home Video Doorbell
Summary of Contents for Meco Smart Home Video Doorbell
-
Page 2: What's In The Box
1. What’s in the box Please consult below checklist for all the components. Video Doorbell USB Cable User Guide Indoor Chime Screw & Tools Double-sided Tape 2. Meet the doorbell 2MP Camera Charging Indicator PIR Motion Sensor Micro USB Port Speakers Reset Indicating LED... -
Page 3: Battery Charging
5. Battery charging The batteries inside the doorbell are not fully charged in accordance with transportation safety regulations. Please charge the batteries with a USB compatible wall charger (not included) and the provided USB cable for about 8~10 hours prior to Wi-Fi configuration and installation. -
Page 4: Run A Test
9:55 9:55 9:55 Wi-Fi Setup Operation Scan QR Code Install Doorbell Select your Wi-Fi network Scan the QR code below with the device at a distance of 5-8 inches. (Please select a 2.4G network, this device will not work with 5G Wi-Fi networks) A tone will be heard when successfully scanned. -
Page 5: Live View Interface
9. Live view interface Quit live viewing Setting menu Battery status Volume on/off HD/SD switch Wi-Fi signal status Stream bit rate Wi-Fi signal status Screenshot button Speak to the scene Record on the phone Body detection on/off Notification history Cloud storage service 10. -
Page 6: Installation
11. Installation Select location 166° Your doorbell has 166-degree view angle and 120-degree human detection range. 5 feet It is suggested to mount your doorbell at least 5 feet (160 cm) 160cm above the ground for the best angle of view and motion detection performance. - Page 7 12. connect the chime supply power to the chime The chime can be powered by an USB compatible phone charger (DC5V 1A). You can also plug the chime to the USB port on your PC/notebook to supply power. (not included) 1.
-
Page 8: Select Ringtone
Select ringtone Enter into Settings->Wireless Chime, there are 4 ringtons available (See to Picture.6). Volume control You can control the volume level for the chime in the Wireless Chime Pairing page (See to Picture.6). Unbind 1. Press and hold reset button on the chime for about 5 seconds till the indicator flashes blue twice, and the chime will be restored to factory default. -
Page 9: Key Features
14. Key features Remote view & control The doorbell will be in “sleep mode” to save power, and can be activated remotely from the CloudEdge App to view and control. Full dulplex audio The doorbell support 2-way audio intercomm. You can see, hear and speak to your visitor even when you are not on the go. -
Page 10: Specification
15. Specification Video doorbell Indoor Chime Video & Audio General Image Sensor 1/2.7” CMOS (2.0MP) Power source DC 5V 1A Hisilicon Lite-OS Power port USB (Type-A) 1920 × 1080 px Resolution Consumption 0.2W Stream HD/SD dual stream Ringtones 4 ringtongs optional High power IR LED with ICR Infrared LED Volume... -
Page 11: Troubleshooting
16. Trouble shooting Q1: Why I failed to set up Wi-Fi for the doorbell? A1: ①.Device works with 2.4GHz Wi-Fi only, but not support 5GHz Wi-Fi. ②.Wi-Fi network is not good, try to keep the camera near the Wi-Fi router when setting up. ③.The Wi-Fi password is wrong. Please check if there are special characters in the password, or the network is specially encrypted.
Need help?
Do you have a question about the Smart Home Video Doorbell and is the answer not in the manual?
Questions and answers