Philips GC9040/02 User Manual page 9

6 To iron with steam, set the temperature dial to 2 or higher.
7 Put the plug in an earthed wall socket.
- Set the on/off knob to 'on'.
- The steam light flashes to indicate that the steam generator is heating
up. After 2 minutes the appliance is ready for use. You hear two beeps,
the steam light stops flashing and stays on. Press the steam trigger for
steam.
- Type GC9040 only: To remove stubborn creases, you can use the steam
boost function. Set the temperature dial between 3 and MAX.
Press the steam boost button.
Never direct the steam at people.
8 Press the steam button to select the desired steam setting.
- ; for moderate steam output and # for high steam output (set a
temperature from 3 to MAX)
- l for low steam output (set a temperature from 2 to MAX).
Note: If you do not use the iron for more than 10 minutes, the appliance
switches off automatically for safety reasons. The automatic shut-off light
flashes. To switch on the appliance again, press any button.
Auto Calc Clean function
This appliance is equipped with an Auto Calc Clean function. Over
time, scale particles build up inside the steam generator. The appliance
automatically performs a Calc Clean process to clean itself from scale after
using 6 to 8 tanks of water.
EnGlish
9