Advertisement
Port Replicator Left
Video: VGA out D-sub 15 pin
Mouse: Mini-DIN 6 pin
Keyboard: Mini-DIN 6 pin
Troubleshooting
Problem
Power In/Out LED's will not light and/or Toughbook not charge.
Solution
Switch power switch to ON position.
1
Make sure power cable is firmly attached
3
to power jack and external 12-28vdc.
Problem
Toughbook will not dock with RAM
Solution
Make sure latch is fully engaged.
1
Latch
Safety Precaution
Do not install this product near or over an airbag deployment area or in a location that obstructs the driver's vision or interferes with vehicle
operation. National Products, Inc does not assume responsibility or liability for any such personal injury, death or property damage.
To see more mounting options, visit rammount.com
rammount.com
1.800.497.7479
support@rammount.com
Port Replicator Front
USB: External USB 2.0
DC Jack: Non functional
Mic: Mono phone jack
Speaker: Speaker/Headphone Stereo phono jack
Make sure fuse is intact and properly seated.
2
Remove fuse, and with voltmeter check
4
voltage across fuse terminals. If polarity is
reversed check all connections; reverse
power cable if necessary.
Tough-Dock
.
®
™
Remove Toughbook from RAM
2
align ribbon cable and press firmly(see A). Use a blunt object to avoid damaging the ribbon cable.
Docking Area
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
for Panasonic Toughbook CF-28, 29, 30 & 31
®
Tough-Dock
™
and make sure ribbon cable is fully seated; if loose
Internal view of ribbon connector
and Port Replicator 1
RAM
Tough-Dock
®
Port Replicator Right
Printer: Parallel port D-Sub 25pin
Serial: Serial port D-sub 9pin
Network: RJ45 connection
POWER
POWER
DOCKED
IN
OUT
Ground
+12-28V
A
RMR-INS-234-PAN1
™
Advertisement
