Veethree GPS SPEEDOMETER Quick Start Manual

1. Install

Installation
Verkabelung
Installi
Instale

2. Wire Connection

Branchement connecteur
Installieren Sie Drähte
Installi connettore
Connector de insta
a. Disconnect battery before wire connections.
b. The Veethree GPS Speedometer displays analog SOG (speed over ground) and digital LCD COG (course over ground).
c. All data is for Reference only. It should not be used as the only source for navigation. Loss of signal and atmospheric changes are possible.
d. It may take 60 seconds or more for the receiver to acquire satellites when the unit is fi rst turned on or if the signal is lost.
e. The GPS Speedometer will display 0 MPH and 3 dashes on the COG until the signal is acquired from satellites.
f. Below speeds of approximately 1.5 MPH (2.5 km/h) the speedometer will not display speed and the heading will remain fi xed at the last head-
ing displayed.
g. The speedometer head is compatible with all receivers, also called antennae, outputting NMEA 0183 data. If you already have such a receiver
in place, the Veethree receiver is not necessary.
h. The connector and terminals for both the Power and Receiver are packaged with the GPS Speedometer head. This allows receiver cord to
fi t through smaller holes with the connectors being assembled at the end of the process. If using other than a Veethree receiver, A NMEA 0183
signal splitter is needed, then making it compatible.
j. Connect battery after all wire connections.
3 13/32 in.
87 mm
1/16 - 1/2 in.
2-13 mm
Power
GPS SPEEDOMETER
COMPTEUR DE VITESSE GPS
GPS GESCHWINDIGKEITSMESSER
TACHIMETRO DI GPS
VELOCÍMETRO DE PUESTO GLOBAL
100 in. oz maximum
0.706 maximum Nm
0.706 Nm max,
0.706 Nm Massimo
0.706 Nm Maximum
Crimp Terminal on Wire, then insert thru connector.
Sertir les broches sur les fi ls et insérer dans le
connecteur.
Die Anschlussklemmen mit dem Kabel verbinden, dann die
Anschlussklemmen durch den Verbindungsstecker führen.
Pigi Terminale su cavo, poi inserisca in connettore.
Unidad terminal de formulario sobre el cable E Insertar into
conector.
Receiver
68866 Revision 2 Page 1 of 2