Silvercrest HBS 3.7 C1 Operating Instructions Manual page 47

Comb attachments
• Remove the comb attachment. Rinse the comb attachment
with water and let it dry before using it again.
Hair trimmer, beard trimmer and precision trim-
mer attachments
1. Figure A: remove the attachment from the hair and beard
trimmer 5 by pressing it with the thumb towards the rear.
2. Remove the hair remnants from the attachment using the
cleaning brush 17 included in the delivery.
3. Apply a few drops of blade oil 16 to the cutting edge of the
attachment. Using a soft cloth, wipe off the surplus oil, if
necessary. Only use acid-free oil, such as e.g. sewing ma-
chine oil.
Nose/ear hair trimmer attachment
• Remove the nose/ear hair trimmer attachment 12. Rinse it
with water and let it dry completely before using it again.
Shaving attachment
WARNING!
Do not detach the shaving foil from the shaving foil frame,
and do not clean it using the cleaning brush 17.
NOTE: from time to time, oil the cutting blade with a few drops
of acid-free oil (e.g. sewing machine oil). Attach the shaving at-
tachment to the hair and beard trimmer 5 and let it run for a few
seconds without using it. Using a soft cloth, wipe off the surplus
oil, if necessary.
,
2 1
, ,
13 14 4
3
12
GB
45