Advertisement
Page 4 of 12
FITTING INSTRUCTIONS
•
To fit the radiator guard to the bike, cut the foam strip provided into 10mm wide pieces and
stick them to the back of the radiator guard frame, so that they sit between the radiator guard
and the radiator (please space these evenly all around the radiator guard frame as they prevent
the guard coming into contact with the radiator).
•
Remove the allen bolt on the RHS of the bike, highlighted in Picture 1.
•
Locate and remove the plastic push rivet on the rear of the panel, shown in Pictures 2 and 3,
by pushing in the centre of the rivet to release it.
•
Carefully remove the plastic fairing panel, by gently pulling it to release the fastener shown in
Picture 4.
•
Repeat the previous steps on the other side of the bike.
•
With the radiator exposed, loosen the two bolts shown in Picture 5, to allow 3mm clearance
between the radiator and the fairing, shown in Picture 6.
•
Repeat the previous step on the other side of the bike.
•
Offer the radiator guard into position, ensuring the four mounting tabs sit over the bolts, and
secure the radiator in place by tightening the four bolts back up to the correct torque.
•
Refit both fairing panels.
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design
changes which do not diminish their performance or visual appeal and supplying them in such state shall conform to the order.
The Buyer acknowledges no representation or warranty (other than as to title) has been given or will apply to the Products other
than those in R&G's order or confirmation and the Buyer confirms it has chosen the Products as being of merchantable quality
and suitable for its particular purposes. Where R&G fits the Products or undertakes other services it shall exercise reasonable
skill and care and rectify any fault free of charge unless the workmanship has been disturbed. The Buyer is responsible for
ensuring that the warranty on the motorcycle is not affected by the fitting of the Products. On return of any defective Products
R&G shall at its option either supply a replacement or refund the purchase money but shall not be liable if the Products have
been modified or used or maintained otherwise than in accordance with R&G's or manufacturer's instructions and good
engineering practice or if the defect arises from accident or neglect. Other than identified above and subject to R&G not limiting
its liability for causing death and personal injury, it shall not be liable for indirect or consequential loss and otherwise its liability
shall be limited to the amounts paid by the Buyer for the Products or the fitting or service concerned. These terms do not affect
the Buyer's statutory rights.
R&G RACING RETURNS POLICY (NON-FAULTY GOODS)
Returns must be pre-authorised (if not pre-authorised the return will be rejected). Goods may only be returned direct to us if they
were purchased direct from us (customer must prove if necessary). Otherwise to be returned to original vendor. Goods must be
in re-sellable condition, in the opinion of R&G Racing. All returns are subject to a 25% restocking and handling fee (25% of the
gross value exc. P&P – at the prevailing price at time of purchase). The customer must pay any and all carriage charges. No
returns of discontinued products, unless within 14 days of purchase. This policy does not affect your statutory rights and does not
refer to faulty goods.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
ISSUE 1
14/09/2018 (LF)
CONSUMER NOTICE
R&G
www.rg-racing.com
4
RAD0234
Email:
info@rg-racing.com
Advertisement
