Advertisement
PROGRAMMING CALLSIGNS
The built-in TNCs of the Commander and Transporter
communicate each other when you send a control
command from the Commander. So you must program
different callsigns (9 digits max.) on these transceivers as
the IDs of the TNCs.
Use the following Menu Nos. to program callsigns:
On Commander
500 COM Callsign
501 TRP Callsign
On Transporter
500 COM Callsign
501 TRP Callsign
1 Access Menu 500 or 501, then [
•
The callsign entry field appears; the first digit blinks.
2 Press [
]/[ ] or rotate the Tuning control to select a
character.
• You can enter 0 to 9, A to Z, and –.
3 Press [ OK].
• The cursor moves to the next digit.
4 Repeat steps 2 and 3 to enter up to 9 digits.
[ESC
]: Cancels entry of a callsign.
[A/B]: Deletes the digit at which the cursor is blinking.
5 Press [ OK]. to complete the setting.
6 Press [MENU] to exit Menu mode.
The keypad also is available to enter alphanumeric
characters in step 2.
PROGRAMMING A TONE FREQUENCY
On receiving a tone from the Commander, the Transporter
causes the HF transceiver to enter Transmit mode. On
both the Commander and Transporter, access Menu 502
and select the desired, same tone frequency.
Callsign for Commander
Callsign for Transporter
Callsign for Commander
Callsign for Transporter
(OK)].
CONTROL OPERATION
When in the Sky Command mode, the keys of the
Commander will function as below. First switch ON the HF
transceiver and press [0] (SYNC) on the Commander.
Each time you press the desired key, the Commander
will automatically enter transmit mode and send the
corresponding control command to the Transporter.
Key
Tuning
control
[A/B]
[1] (PWR)
[2] (RX)
[3] (MODE)
[4] (RIT)
[5] (XIT)
[6] (CLR)
[7] (SPLIT)
[8] (M>V)
[0] (SYNC)
[MONI]
[B] (M/V)
[
]
[ ]
[ ]
1
(FAST)
[#]
2
(ENTER)
[PTT]
1
"FS" appears when you select 1 kHz step (LSB/ USB/ CW) or 10 kHz
step (FM/ AM).
2
After pressing [#], press [0] to [9] to enter a frequency or memory
channel number.
SKY CMD – 3
Tuning control
Function
Frequency or memory channel number
change
In VFO mode: VFO A/ VFO B switch
In Memory Recall mode: no change
Power ON/ OFF
HF frequency receive ON/ OFF
Modulation mode switch
RIT ON/ OFF
XIT ON/ OFF
RIT offset or XIT offset clear
Split-frequency ON/ OFF
Transfer from Memory to VFO
Current settings retrieve (from HF
transceiver)
To monitor the UHF band on the
Commander
VFO/ Memory Recall mode switch
XIT/ RIT offset frequency increase
XIT/ RIT offset frequency decrease
In LSB, USB, or CW mode: 10 Hz/ 1 kHz
switch
In FM or AM mode: 1 kHz/ 10 kHz switch
In VFO mode: frequency entry ON
In Memory Recall mode: channel number
entry ON
To transmit audio on an HF frequency
Advertisement
