Advertisement
(2) RS-232C Connector
Connect one end of an appro-
priate RS-232C cable to th is connector. Connect the
other end of the cable to the device with which you
wish to communication.
(3) PC Interface Connector Plug this connector into the
connector on the left side of the PC-2 or on the rear
panel of the PC-2 Printer/Plotter/Dual Cassette Inter-
face.
(4) AC Adapter
To use an external power supply or to
recharge, plug the AC Adapter into the Interface
Power Supply Jack.
(See recharging instructions
before attempting to use the PC-2 RS-232C Inter-
face.)
(5)
Choke Cable. (U.S.A. only) Plug this cable into the
Printer/Plotter/Dual
Cassette
Interface's
External
Power Supply Jack.
(6)
Metal Support Bracket A.
Protects the connection
between the PC-2 and the PC-2 RS-232C Interface.
(7)
Printer/Plotter/Dual Cassette Interface Metal Support
Bracket B.
Protects the connection between the
Printer/Plotter/Dual Cassette Interface and the PC-2
RS-232C Interface.
Requires two screws for attach-
ment (included in the package).
4
2/ Setting-Up the PC-2 RS-232C
Interface
The PC-2 RS-232C Interface can be used with or without
a Printer/Plotter/Dual Cassette Interface. For this reason,
there are two sets of diagrams which illustrate how to
set-up the system.
Be sure to turn all equipment OFF before attempting to
connect the PC-2 RS-232C Interface.
Connecting the PC-2 to the RS-232C Interface
If you are using the PC-2 without a Printer/Plotter/Dual
Cassette Interface, follow these steps:
1. Slide Metal Support Bracket A into the slots located on
the base of the PC-2 (Figure 2).
Bracket A
Figure 2. Connecting Metal Support Bracket A
to the
PC-2.
2. Remove the Interface Covers from both the PC-2 and
the RS-232C Interface.
Locate the notch on the
underside of the PC-2 and slide it into the tab of Metal
Support Bracket A.
5
Advertisement
