Table of Contents
Advertisement
To clean the air filter
1.
Brush any loose dust off of the filter.
2.
Place the filter under warm running water to remove any remaining dust. On one side of the filter is a foam
filter material. When rinsing, water should flow out of this side.
3.
Remove the filter from the water and thoroughly pat dry with a towel to remove any moisture.
To replace the clean, dry filter into the frame door
1.
Place the clean air filter across the metal protective screen, orienting it in the same position you found it in
during step 1 of the procedure "To remove the air filter from the frame door".
2.
Install the faceplate by gently fitting it back onto the frame door, ensuring the faceplate does not interfere with
the Diagnostic Panel, the
3.
Verify that the side door tabs are seated properly in the cutouts on the frame door bracket.
4.
Using a Phillips screwdriver, secure the faceplate using the four screws removed during step 2 of the procedure
"To remove the air filter from the frame door".
Replacing the Frame Air Filter
Order the Air Filter Replacement Kit from your openGear sales representative before replacing the frame air filter in
your AG 4800X/XS frame.
To remove the old air filter from the frame door
Using a Phillips screwdriver, remove the four 3/16"screws screws that secure the faceplate. Set the screws
1.
aside. (Figure 8.2)
2.
Ensure that the side door tabs are disengaged from the door.
3.
Remove the faceplate by gently pulling it towards you while avoiding the Diagnostic Panel, the
and the STATUS LED.
4.
Gently remove the air filter off the metal protective screen that separates the filter from the fans.
To install the new filter into the frame door
1.
Place the new air filter across the metal protective screen, orienting it in the same position you found it in
during step 1 of the procedure "To remove the old air filter from the frame door".
2.
Install the faceplate by gently fitting it back onto the frame door, ensuring the faceplate does not interfere with
the Diagnostic Panel, the
3.
Verify that the side door tabs are seated properly in the cutouts on the frame door bracket.
4.
Using a Phillips screwdriver, secure the faceplate using the four screws removed during step 1 of the procedure
"To remove the old air filter from the frame door".
Page | 28
Toggle
button, and the STATUS LED.
Figure 8.2 AG 4800X/XS — Screw Locations on Front Panel
button, and the STATUS LED on the frame door.
Toggle
button,
Toggle
Advertisement
Table of Contents
