Scout Carbon Paramotor User Manual page 6

5 Paramotor assembly
Tips for cage assembly
SCOUT paramotor comes completely assembled and pilot only needs to install the cage and
propeller. For assembly, please follow these steps:
1. lay the paramotor down, engine facing down
2. Insert the Enduro stand by pusing the
brass pins, make sure the pins pop out.
You will regret later if you forget this now
:-)
3. Now your can flip your parmaotor in the
normal standing position.
4. install first Carbon DTC spar on to the main
frame. Start with the right bottom one, the
one that is near the fuel tank cap.
5. install the low ring section
6. Step on the stand, push the main frame
away from you still holding the stand with
your foot to make room for the ball joint to
enter in the bottom hoop CNC machined
hole.
7. install all other carbon spars like on this
picture (second picture)
8. Take the 5 ring sections out of the bag,
keep them folded together.
9. Keep the carabiner locked throughout the
whole process - this prevents the netting
from tangling.
10. Look at the INNER ring section and find out
which side it fits.
11. Approach the paramotor from front so that
the netting stays in front of the arms.
12. Place the inner ring section on to the lower
arm on respective side while still keeping
all folded ring sections together. .
13. Leave the other end of the first ring
section free. Leave the free end of the
section on the OUTER side.
14. While the first section is in place, "unfold" the
remaining four and place the inner section on
the next arm (3 or 9 o'clock).
15. Repeat with all other sections
It may be necessary to unlock the
16.
carabiner on the netting to be able to put
the last ring section in place
At this point you should end up with all
17.
sections pushed half-way only with one
end.
Now finish the assembly of the cage by
18.
pushing the section onto the arms until
Proudly designed and manufactured in Slovakia. (www.scoutparamotor.com)
User manual.
6