Kessler Digital Rev Head Quick Start Manual

G ETT IN G S TARTED
• CONTROL VIA SECOND SHOOTER / SECOND SHOOTER PLUS (SS/SS+)
• CONNECT
SS+ Controller.
• CONNECT
Controller.
• CONNECT
• POWER UP
keys on the controller for manual moves or programmed moves. Similar to operating the Second
Shooter Pan/Tilt Head.
• JOYSTICK CONTROL VIA DIGITAL CONTROL CENTER & SECOND SHOOTER/SECOND
SHOOTER PLUS
• SYSTEM REQUIRMENTS:
• DCC Firmware: Digital Control Center for Second Shooter V1.1.0.12
• Second Shooter Firmware: Second Shooter V0.3.8.8
• Second Shooter Plus Firmware: Second Shooter Plus V0.4.6.1
• All firmware can be downloaded at support.kesslercrane.com
• CONNECT
SS+ Controller.
• CONNECT
Controller.
• CONNECT DCC TO
expansion ports.
• CONNECT
powered individually)
• POWER UP SS/SS+ &
SS+ controller into Slave Mode.
• SLAVE
select
• OPERATE DIGITAL REV
the joystick for manual moves or programmed moves.
DIGITAL REV HEAD

Quick Start Guide

PAN: Connect Cat-5 to RJ-45 Connection for pan and to the pan port on the SS/
TILT: Connect Cat-5 to RJ-45 Connection for tilt and to the tilt port on the SS/SS+-
POWER: Connect power to the SS/SS+ Controller.
SS/SS+: You can now operate the Digital Rev Head via SS/SS+ utilizing the arrow
PAN: Connect Cat-5 to RJ-45 Connection for pan and to the pan port on the SS/
TILT: Connect Cat-5 to RJ-45 Connection for tilt and to the tilt port on the SS/SS+-
SS/SS+: Connect bridge cable from DCC to the SS/SS+ Controller via the
POWER: Connect power to the SS/SS+ Controller and the DCC (Each unit must be
DCC: DCC will display
MODE: When SS/SS+ Controller is powered up the screen will give the option to
STAND ALONE or SLAVE
HEAD: You can now operate the Digital Rev Head via DCC utilizing
MOTORS OFFLINE
MODE. Select SLAVE
until you have set your SS/
MODE.