Falcon REF 072228 Installing page 25

Instructions for synchronizing the receiver
and the remote control
The fan control does not require synchronization with the
receiver. Communication is universal with the receivers of this
model.
The fans installed in the same operating area respond to the
same control.
This fan has two synchronization modes: Universal Mode and
Unit Mode:
For both synchronization modes, make sure that the switch
located inside the battery compartment of the remote con-
trol is in the ON position:
ON DIM
UNIVERSAL MODE:
- This type of synchronization allows you to control one or
more nearby fans with the same remote control.
- Synchronization:
1. Connect the power (wall switch) of the fan or fans, and
just then, within the next 60 seconds, press the key on the
remote control for 6 continuous seconds.
2. The fan light will flash and the fan will start rotating for
90 seconds in one direction. It will stop and automatically turn
90 seconds in the opposite direction. Do not press any key
until the process is complete.
3. Now, the transmitter and receiver of the fan/s will have
been synchronized. Remove the current of the fan/s by means
of the switch or the breaker and then immediately turn it/
them on, this step is the one that closes the synchronization
process.
UNIT MODE:
- This type of synchronization allows you to control two or
more nearby fans independently, each with its remote control.
- Synchronization:
1. Connect the power (wall switch) of a single fan, and just
then, within the next 60 seconds, press the key on the re-
25
EN