Factory Reset; Reset Settings; Adding Or Removing Sensors To The Vessel - Mercury Racing VesselView Installation, Calibration & Operation Manual

Table of Contents

Advertisement

8. If there are multiple engines, press the down arrow on the arrow trackpad to proceed
to the "LEFT SCREEN".
9. Press the left or right arrow on the arrow trackpad to scroll through the available location
types.
10. For three or four engine applications, press the down arrow on the arrow trackpad to
proceed to "CENTER SCREEN".
11. Confirm your selections by pressing the check button.
12. VesselView will display the "SAVING SETTINGS" screen and restart.

Factory Reset

The factory reset option is used to reset all VesselView settings to factory default or to
perform a sensor detection. To perform a factory reset function, press the menu button
until the "Main" menu appears, then "Calibrate" > "Factory Reset".

RESET SETTINGS

IMPORTANT: By selecting "RESET SETTINGS" all session changes made to the
VesselView screens or system will be lost. It is recommended that you save your settings
before performing a reset of the system. Refer to Section 1 ‑ Saving Settings.
1. The factory reset screen will ask you to "CHOOSE RESET TYPE". The two types of
resets are:
2. Use the left or right arrow on the arrow trackpad to highlight "RESET SETTINGS".
3. Press the check button to confirm. A yellow pop‑up message will appear asking "ARE
YOU SURE YOU WANT TO RESET SETTINGS?".
4. Press the check button to continue or the X button to go back to the previous screen.
By pressing the check button, VesselView will reset all settings to factory default and
restart with the setup wizard. Refer to Section 2 - Setup Wizard.

ADDING OR REMOVING SENSORS TO THE VESSEL

IMPORTANT: "RESET SENSOR DETECTION" will not cause any session changes to be
lost.
When VesselView Race Edition is first configured (during the setup wizard) the system will
automatically detect sensors that are present and ignores sensor inputs that have no
sensors attached.
90-8M8022154 APRIL 2008
"RESET SETTINGS" ‑ This will reset VesselView to factory defaults.
"RESET SENSOR DETECTION" ‑ This will scan the VesselView network for any
recently removed or installed sensors.
a
a -
Reset settings directory
b -
Pop‑up message
Section 4 - Main Menu
b
27130
Page 81

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the VesselView and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents