Advertisement
Anleitung D6 VHHC SPK7
21.02.2006
GB
Starting up:
Charging the battery pack (Figure 2)
1. Check that your mains voltage is the same as that
marked on the rating plate of the battery charger.
Plug the charger into the socket and connect the
charging cable to the charging jack (10) on the
cordless vacuum cleaner.
2. The red LED indicates that the battery pack is
charging. The time it takes to fully recharge an
empty battery is approximately 8 hours. The
charging time for a partially charged battery is
comparatively less. The temperature of the battery
pack may rise slightly during the charging
operation. This is normal.
Important! When the battery pack is fully
charged the charger does not cut out
automatically, please remember to unplug the
charger once the unit is fully charged as
failure to do so will damage the battery.
DO NOT LEAVE the unit on charge continuously
this will damage the battery.
If the battery pack fails to charge, please check
whether there is voltage at the socket-outlet
whether there is perfect contact to the charging
jack on the cordless hand-held vacuum cleaner.
If the battery pack still will not charge, please send
the power supply unit
and the cordless vacuum cleaner
to our after-sales service department.
To ensure that the battery pack provides long service
you should take care to recharge it promptly. This is
definitely required if you find that the power of the
cordless hand-held vacuum cleaner falls.
Never fully discharge the battery pack. This will
cause it to develop a defect.
Operation (Figure 1)
Take the cordless hand-held vacuum cleaner out of
its mounting (5) and slide the On switch (7) forwards.
The vacuum cleaner will stop automatically when you
release the On switch. The green LED indicates that
the vacuum cleaner is operating. Before you vacuum
any liquids or wet items, empty the dust tank and
clean the filter.
The dust tank (6) can be removed and emptied by
pressing the release button (9). We recommend that
you empty the dust tank after each time you use the
vacuum cleaner.
4
8:42 Uhr
Seite 4
Filter cleaning (Figure 3)
Clean the dirty filter with soap suds and then hang it
up to dry. Insert the dry filter and start the vacuum
cleaner again.
Ensure that all the individual parts have been assem-
bled again correctly.
Technical data:
Motor voltage supply
Battery charging voltage
Battery charging current
450 mA
Charger mains voltage
230 V ~ 50 Hz
Ordering replacement parts
Please quote the following data when ordering repla-
cement parts:
Ttype of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
!
iNTERNATiONALES SERViCE CENTER GmbH
Rechargeable batteries and cordless electric machi-
nes and tools contain materials that are potentially harm-
ful to the environment. Never place any cordless electric
machines or tools in your household refuse. When cord-
less electric machines or tools become defective or worn,
remove the rechargeable batteries and return them to
iSC GmbH Eschenstrasse 6, D-94405 Landau, Germany.
If the rechargeable batteries cannot be removed, return
the complete cordless machine or tool. You can then be
sure that the equipment will be correctly disposed of by
the manufacturer.
6 V=
9 V=
Advertisement
