Storing The Appliance - Princess 332835 User Instructions

can remove the tube from the handle by
pressing the locking button and pulling
the handle out of the tube.
Use
Always make sure all the filters and the
dust collector are correctly fitted before
using the appliance. Damaged or
incorrectly fitted filters may cause damage
to the appliance.
Preparations
1 Adjust the telescopic tube to the
required length (see figure 4). Push the
locking button in the direction indicated
by the arrow on the button. Keep the
locking button pressed and extend or
retract the telescopic tube. Release the
locking button to lock the telescopic
tube to the desired length.
2 Fit the combi nozzle or one of the other
accessories to the end of the tube. You
can also fit the combi nozzle or one of
the other accessories directly to the end
of vacuum cleaner hose handle.
The combi nozzle has two settings: with
a brush for vacuuming hard floors
(parquet, tiles, linoleum, etc.) and
without a brush for vacuuming soft
floors (carpet, etc.). Press the button on
the combi nozzle to either vacuum with
a brush ( ) or without a brush
( ) (see figure 5).
Vacuuming
1 The power cord has a yellow mark and
a red mark on it (see figure 6). Extend
the power cord beyond the yellow mark.
The red mark indicates the end of the
power cord. Never extend the cord
beyond the red mark. This could
damage the power cord.
2 Insert the plug into a plug socket and
press the On/Off switch. Press the On/
Off switch again to turn the appliance
off.
3 Use the handle on the vacuum cleaner
hose to move the appliance back and
forth whilst vacuuming. You can lift the
8 Cyclone Cleaner Article 332835 / 332836
appliance using the vacuum cleaner's
handle.
Note! Never lift the vacuum cleaner
using the dust collector's handle!
4 The suction force can be adjusted
whilst vacuuming using the button that
adjusts the suction force. The suction
force can also be temporarily reduced
by opening the air supply control slide
on the vacuum cleaner hose handle.
5 Press the On/Off button to turn the
appliance off.
Accessories
Besides the combi nozzle for cleaning
large surfaces, there are also two (Red
Panda Cyclone Cleaner) or three (Black
Rhino Cyclone Cleaner) accessories for
cleaning smaller and special surfaces:
• A crevice tool, to clean radiators, window
frames, crevices, small openings, etc.
• A small nozzle, to clean delicate or
irregular surfaces, furniture, Venetian
blinds, etc.
• A parquet brush, to clean parquet floors
(only available with the Black Rhino
Cyclone).

Storing the appliance

1 Remove the plug from the plug socket.
2 Lightly hold the end of the power cord.
Press the cord rewind button and allow
the cord to gently slide through your
fingers back into the appliance.
Note! You must guide the cord whilst it
is rewinding. If you do not do so, the
cord may become tangled or the plug
may strike the back of the appliance.
This can damage the appliance or the
power cord.
3 Stand the vacuum cleaner upright. Fully
retract the telescopic tube. A slot for the
telescopic tube is located at the bottom
of the vacuum cleaner, next to the front
castor. Slide the holder on the telescopic
tube into the slot (see figure 7). This
avoids the need to dismantle the
vacuum cleaner after use; you can
store the assembled appliance and