Advertisement
EnGlISH
Introduction
Congratulations on your purchase and welcome to TRESemmé Philips! To
fully benefit from the support that Philips offers, register your product at
www.philips.com/welcome.
General description (Fig. 1)
A Volume diffuser
B Concentrator
C Air outlet grille
D Cool shot button
E Temperature slide switch
-
6 Hot setting
-
5 Warm setting
-
4 Cool setting
F Airflow slide switch
-
II = Strong airflow for quick drying
-
I = Gentle airflow specially intended for styling
-
0 = Off
G Hanging loop
H Ion slide switch
I
Ion indicator light
J
Air inlet grille
Important
Read this user manual carefully before you use the appliance and save it for
future reference.
Warning
-
Do not use this appliance near water. Do not use this appliance near
bathtubs, showers, basins or other vessels containing water (Fig. 2).
-
When you use the appliance in a bathroom, unplug it after use. The
proximity of water presents a risk, even when the appliance is switched
off.
-
Do not insert any objects into the appliance to avoid electric shock.
-
Check if the voltage indicated on the appliance corresponds to the local
mains voltage before you connect the appliance.
-
Check the condition of the mains cord regularly. Do not use the
appliance if the plug, the mains cord or the appliance itself is damaged.
-
If the mains cord is damaged, you must have it replaced by Philips, a
service centre authorised by Philips or similarly qualified persons in
order to avoid a hazard.
-
This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for
their safety.
-
Children should be supervised to ensure that they do not play with the
appliance.
Caution
-
For additional protection, we advise you to install a residual current
device (RCD) in the electrical circuit that supplies the bathroom. This
RCD must have a rated residual operating current not higher than
30mA. Ask your installer for advice.
-
Never block the air grilles.
-
The appliance has a safety function. If the appliance overheats, it
switches off automatically. Unplug the appliance and let it cool down
for a few minutes. Before you switch on the appliance again, check the
grilles to make sure they are not blocked by fluff, hair, etc.
-
Always switch off the appliance before you put it down, even if it is only
for a moment.
-
Always unplug the appliance after use.
-
Do not wind the mains cord round the appliance.
-
You may notice a characteristic odour when you use this hairdryer. This
odour is caused by the ions that are generated and is not harmful to
the human body.
-
Do not use the appliance on artificial hair.
-
Do not use the appliance for any other purpose than described in this
manual.
-
This appliance is only intended for drying scalp hair.
-
Keep the hairdryer clean and free of dust, dirt and styling products such
as mousse, spray and gel.
-
Never use any accessories or parts from other manufacturers or that
are not specifically advised by Philips. If you use such accessories or
parts, your guarantee becomes invalid.
A
B
C
D
E
F
2
6
10
Electromagnetic fields (EMF)
This Philips appliance complies with all standards regarding electromagnetic
fields (EMF). If handled properly and according to the instructions in this
user manual, the appliance is safe to use based on scientific evidence
available today.
Using the appliance
Drying
1
Put the plug in the wall socket.
2
Select the desired airflow setting to switch on the appliance (Fig. 3).
-
Set the slide switch to airflow setting II for ultra-quick drying.
-
Set the slide switch to airflow setting I for drying short hair or styling
your hair.
3
Set the temperature slide switch to the cool, warm or hot
setting (Fig. 4).
-
The hot setting 6 allows you to dry shower-wet hair very quickly and
safely until it is damp.
-
The warm setting 5 is especially suitable for drying damp hair until it is
almost dry.
-
The cool setting 4 allows you to gently dry hair that is almost dry and
helps to seal in shine.
4
Switch the ion function on or off with the ion slide switch (Fig. 5).
The ion indicator light goes on to indicate that the ion function has
,
been activated.
The ion function provides additional shine and reduces frizz and static
electricity. It is particularly suitable for dry and almost-dry hair.
5
Dry your hair by making brushing movements with the hairdryer at a
small distance from your hair (Fig. 6).
Tip: When you have finished drying each section, press the cool shot button and
direct the cool airflow at your hair. This fixes your style and adds shine.
Concentrator
The concentrator enables you to direct the airflow straight at the brush or
comb with which you are styling your hair.
1
Snap the concentrator onto the appliance (Fig. 7).
To disconnect the concentrator, pull it off the appliance.
G
3
4
7
8
11
1
J
I
H
5
9
Advertisement
