Troubleshooting - Klarstein 10032903 Manual

TROUBLESHOOTING

Fault
Light on, but fan does not
work.
Both light and fan do not
work.
Grease exits.
Light is not working.
The suction performance is
not good.
The cooker hood hangs at
an angle.
Note: Any electrical repairs to this appliance must conform to your local, state and
federal laws. Please contact the costumer service if in any doubt before undertaking
any of the above. Always disconnect the unit from the power source when opening
the unit.
Possible Cause
The Fan switch turned off.
The fan switch is defective.
The motor is damaged.
The house fuses are blown. Reset or replace the fuses.
The power cord is loose or
not connected.
One way valve and
the outlet are not tightly
sealed.
The connection of chimney
and cover leaks
The bulb is defective.
The distance between the
cooker hood and cooking
plane is too far.
The fixing screw is not tight
enough.
Solution
Select another fan switch
position.
Contact costumer service.
Contact costumer service.
Refit the plug of the power
cord into the wall outlet.
Switch power outlet on, if
necessary.
Remove the one-way
valve and seal it with
sealant.
Take chimney down and
seal.
Have the bulb replaced
according to the instruc-
tions.
Reduce the distance
between the cooker hood
and the cooking surface to
65-75 cm.
Tighten the hanging
screw and align the hood
horizontally.
EN
31